MS45 Pinout (Siemens DME Bench Pinout)

Bench pinout for the Siemens MS45.0 and MS45.1 DME. Use the pins below to power the DME and talk to it over K-Line when reading or flashing on the bench. All bench connections are on the 9-pin power connector, the first connector on the left (circled in green).

MS45 DME bench pinout diagram showing 12V pins 1, 2, 7, 8, 9, ground pins 5, 6 and K-Line pin 3
MS45 DME bench pinout – 9-pin power connector highlighted.

MS45 bench pins

FunctionMS45 pin(s)
+12 V1, 2, 7, 8, 9
Ground5, 6
K-Line3

Which cars use the MS45 DME?

The Siemens MS45.0 and MS45.1 DMEs are used in E46, E83 (X3), E85 (Z4) and E60 BMWs. Not sure what you have? Use our ECU identification guide.

How to bench flash an MS45

  1. Connect a stable 12 V supply to DME pins 1, 2, 7, 8 and 9, and to the KDCAN cable’s 12 V pin (OBD pin 16).
  2. Connect ground to DME pins 5 and 6, and to the KDCAN cable’s ground (OBD pins 4 and 5).
  3. Connect the KDCAN cable’s K-Line (OBD pin 7) to DME pin 3.
  4. Open MS45 Quickflash and read or flash the DME as you would over OBD.

The KDCAN cable needs 12 V and a ground shared with the DME to communicate, just like it gets from the OBD port in the car. Tip: double-check every connection with a multimeter before powering up, and use a power supply rather than a weak battery charger.

Do I need to bench flash?

Usually not. MS45 Quickflash reads and flashes MS45.0 and MS45.1 DMEs through the OBD port, with EWS delete, VIN/AIF updating and live datalogging. The bench pinout is for DMEs that are out of the car, being tested, or recovering from a failed flash.

Related MS45 tools