Bench pinout for the GS20 transmission control unit (TCU). Use the pins below to power the TCU and talk to it over K-Line when reading or flashing on the bench. All bench connections are on the 9-pin power connector, the first connector on the left (circled in green).
GS20 bench pins

| Function | GS20 pin(s) |
|---|---|
| +12 V | 1, 2, 7, 8, 9 |
| Ground | 5, 6 |
| K-Line | 3 |
Which cars use the GS20?
The GS20 controls the BMW A5S 360R / GM 5L40E 5-speed automatic, used in the E46 330i ZHP, E83 X3 and others. Not sure what you have? Use our ECU identification guide.
How to bench flash a GS20
- Connect a stable 12 V supply to TCU pins 1, 2, 7, 8 and 9, and to the KDCAN cable’s 12 V pin (OBD pin 16).
- Connect ground to TCU pins 5 and 6, and to the KDCAN cable’s ground (OBD pins 4 and 5).
- Connect the KDCAN cable’s K-Line (OBD pin 7) to TCU pin 3.
- Open GS20 Transmission Quickflash and read or flash the TCU as you would over OBD.
The KDCAN cable needs power and a ground shared with the TCU to communicate, just like it gets from the OBD port in the car. Tip: double-check every connection with a multimeter before powering up, and use a power supply rather than a weak battery charger.
Do I need to bench flash?
Usually not. GS20 Transmission Quickflash flashes the GS20 transmission computer through the OBD port. The bench pinout is for TCUs that are out of the car, being tested, or recovering from a failed flash.
Related GS20 tools
- GS20 Transmission Quickflash – OBD transmission flashing
- All transmission flash tools
- All ECU & TCU bench pinouts
