MEVD17.2 Pinout (MEVD17.2, 17.2.4, 17.2.6, 17.2.9 Bench Pinout)

Bench pinouts for the Bosch MEVD17.2 DME family. There are two different layouts: one for MEVD17.2 and MEVD17.2.6 (N55) and one for MEVD17.2.4 and MEVD17.2.9 (N20/N2x). Check which variant you have before wiring. All MEVD17.2 E-Series DMEs communicate over D-CAN.

MEVD17.2 / MEVD17.2.6 bench pins

MEVD17.2 and MEVD17.2.6 bench pinout diagram showing 12V pins 42, 46, ground pin 30, CAN High pin 8 and CAN Low pin 7
MEVD17.2 / MEVD17.2.6 bench pinout.
FunctionMEVD17.2 / 17.2.6 pin(s)
+12 V42, 46
Ground30
CAN High8
CAN Low7

Used on N55 engines: E-Series 135i, 335i, X1, X5 and X6 (MEVD17.2 and 17.2.6, flashed with N55e Quickflash)

MEVD17.2.4 / MEVD17.2.9 bench pins

MEVD17.2.4 and MEVD17.2.9 bench pinout diagram showing 12V pins 1, 22, ground pin 10, CAN High pin 28 and CAN Low pin 13
MEVD17.2.4 / MEVD17.2.9 bench pinout.
FunctionMEVD17.2.4 / 17.2.9 pin(s)
+12 V1, 22
Ground10
CAN High28
CAN Low13

Used on N20 engines in the E84 X1 and E89 Z4 (flashed with N20e Quickflash)

How to bench flash an MEVD17.2

Use the pins for your variant from the tables above.

  1. Connect a stable 12 V supply to DME the +12 V pins for your variant, and to the KDCAN cable’s 12 V pin (OBD pin 16).
  2. Connect ground to DME the ground pin, and to the KDCAN cable’s ground (OBD pins 4 and 5).
  3. Connect the KDCAN cable’s CAN High (OBD pin 6) to DME the CAN High pin.
  4. Connect the KDCAN cable’s CAN Low (OBD pin 14) to DME the CAN Low pin.
  5. Open the Quickflash for your engine and read or flash the DME as you would over OBD.

The KDCAN cable needs 12 V and a ground shared with the DME to communicate, just like it gets from the OBD port in the car. Tip: double-check every connection with a multimeter before powering up, and use a power supply rather than a weak battery charger.

What about F- and G-Series?

These pinouts are for E-Series DMEs only. F- and G-Series BMWs (including MEVD17.2.3, 17.2.5, 17.2G and 17.2P DMEs) require an ENET cable with a gateway rather than K-Line or D-CAN, so they aren’t covered by these bench pinouts. Not sure which you have? Use our ECU identification guide.

Related MEVD17.2 tools